AutoCodes - OBDII Code List - B1182 LEXUS

B1182 LEXUS - Driver Side Air Bag Module Second Stage Squib Circuit Short To Ground

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Comments  |  Add Comment

B1182 LEXUS Possible Causes

  • Faulty Driver Side Air Bag Module Second Stage Squib
  • Driver Side Air Bag Module Second Stage Squib harness is open or shorted
  • Driver Side Air Bag Module Second Stage Squib circuit poor electrical connection
  • Faulty Air Bag Sensor Assembly

How do I fix code B1182 LEXUS

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1182 LEXUS code

Labor: 1.0

The cost of diagnosing the B1182 LEXUS code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B1182 Lexus Description

The Driver Side Air Bag Module Second Stage Squib Circuit consists of the Air Bag Sensor Assembly, Spiral Cable and Driver Side Air Bag Module. The squib causes Driver Side Air Bag to deploy when all deployment conditions are satisfied.
OBDII Code B1182 Lexus - Driver Side Air Bag Module Second Stage Squib Circuit Short To Ground - AutoCodes.com

B1182 LEXUS More Information

Need more information on how to fix the B1182 LEXUS code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1182 Lexus code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1182 Lexus code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧