Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
To diagnose the B1170 Mercury code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The Power Running Board (PRB) module provides a regulated 10-volt power supply to the Hall-effect sensor (internal to the PRB motor) through the circuit. The Hall-effect ground is provided by the PRB module through the circuit. The PRB module monitors the PRB Hall-effect signal through the circuit. If the PRB module does not receive any signal from the Hall-effect sensor during operation, the PRB will stop. The PRB module sets this Diagnostic Trouble Code (DTC) if it does not see any feedback from the Hall-Effect sensor during the stowing/deploying of the RH running board.
Need more information on how to fix the B1170 Mercury code? Get Access to Factory Service Manuals
Get the B1170 Mercury code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1170 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks