AutoCodes - OBDII Code List - B1135 TOYOTA

B1135 TOYOTA - Half Connection In Airbag Sensor Assembly Center Connectors

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

B1135 TOYOTA Possible Causes

  • Faulty Airbag Sensor Assembly Center
  • Airbag Sensor Assembly Center harness is open or shorted
  • Airbag Sensor Assembly Center circuit poor electrical connection

How do I fix code B1135 TOYOTA?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Cost of diagnosing the B1135 TOYOTA code

Labor: 1.0

The cost of diagnosing the B1135 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B1135 TOYOTA Description

The airbag sensor assy center detects partial connection of connector. DTC B1135 is recorded when the airbag sensor assy center detects an open in the electrical connection check mechanism of the airbag sensor connector or in the airbag sensor circuit.
OBDII Code B1135 Toyota - Half Connection In Airbag Sensor Assembly Center Connectors - AutoCodes.com

More Information

Need more information on how to fix the B1135 TOYOTA code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1135 Toyota code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1135 Toyota code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Top ⇧