AutoCodes - OBDII Code List - B1134 NISSAN
B1134 NISSAN - Left Right Side Air Bag Module Open
Table of contents
Share:
B1134 NISSAN Possible Causes
- Faulty Left Right Side Air Bag Module
- Left Right Side Air Bag Module harness is open or shorted
- Left Right Side Air Bag Module circuit poor electrical connection
How do I fix code B1134 NISSAN?
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the B1134 NISSAN code
Labor: 1.0
The cost of diagnosing the B1134 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.Possible Symptoms
- Air Bag Warning Light ON
B1134 NISSAN Description
In case of collision whose acceleration exceeds the specified level, the ignition materials are ignited by the electric ignition system. The system burns and introduces the chemical reaction of gas generating materials to generate hot gases that flow into the air bag through a filter and expand the bag.Front Left Side Air Bag Module mainly consists of air bag and inflator which inflates the air bag.
More Information
Need more information on how to fix the B1134 NISSAN code?Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Need more help?
Get the B1134 Nissan code diagnosed by a professional: Find a repair shop in your areaComments
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1134 Nissan code? Have you replaced any parts?Any information is appreciated. Thanks