AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mercury - B10E7 Mercury

B10E7 Mercury Code - Ignition On Relay

- Code Popularity: 1,316 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B10E7 Mercury?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Ignition On Relay
  • Ignition On Relay harness is open or shorted
  • Ignition On Relay circuit poor electrical connection
  • Faulty Body Control Module (BCM)
⚠ Does your Mercury have Safety Recalls? → Check here

How to Fix the DTC B10E7 Mercury?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

B10E7:12 Ignition On Relay Short To Battery
B10E7:14 Ignition On Relay Circuit Short To Ground or Open

Search for B10E7 Mercury Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B10E7 Mercury code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B10E7 Mercury Description

Conventional Ignition Switch:
The ignition switch is a multiple position rotary switch that is controlled by a lock cylinder and a key. The ignition switch provides voltage to the ACC, ON, or START-designated circuits depending on the position it is placed. The Body Control Module (BCM) calculates the positions based on the voltage received from the ACC and ON-designated circuits.
The key removal inhibit solenoid (also known as the key release interlock actuator) is an electronically controlled solenoid that prevents the ignition lock cylinder from being turned to the OFF position unless the gear selector lever is in the PARK position. The key removal inhibit solenoid is part of the ignition switch.

Push Button Ignition Switch:
The push button ignition switch is used instead of a conventional ignition switch to achieve the various ignition modes. The push button ignition switch is a momentary dual contact switch. Both sets of contacts are normally open and receive the voltage at all times. When the START/STOP button is pressed, the voltage is sent to the BCM, the RFA module, and the PCM to indicate a button press.
The ignition switch has a LED for switch illumination when the backlighting is activated.

OBDII Code B10E7 Mercury - Ignition On Relay - AutoCodes.com
B10E7 Mercury Code - Ignition On Relay

Need More Information on the Code?

Need more information on how to fix the B10E7 Mercury code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B10E7 Mercury code diagnosed by a professional: Find a repair shop in your area

Code B10E7 Mercury comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B10E7 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks