AutoCodes - Mazda - B10E7 MAZDA

B10E7 MAZDA Code - Ignition On Relay

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|B10E7 MAZDA code possible causes

  • Faulty Ignition On Relay
  • Ignition On Relay harness is open or shorted
  • Ignition On Relay circuit poor electrical connection
  • Faulty Body Control Module (BCM)

|How do I fix the B10E7 MAZDA code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B10E7 MAZDA code tech notes

B10E7:12 Ignition On Relay Short To Battery
B10E7:14 Ignition On Relay Circuit Short To Ground or Open

|Cost of diagnosing the B10E7 MAZDA code

Labor: 1.0

The cost of diagnosing the B10E7 MAZDA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B10E7 MAZDA code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|B10E7 MAZDA code description

Conventional Ignition Switch:
The ignition switch is a multiple position rotary switch that is controlled by a lock cylinder and a key. The ignition switch provides voltage to the ACC, ON, or START-designated circuits depending on the position it is placed. The Body Control Module (BCM) calculates the positions based on the voltage received from the ACC and ON-designated circuits.
The key removal inhibit solenoid (also known as the key release interlock actuator) is an electronically controlled solenoid that prevents the ignition lock cylinder from being turned to the OFF position unless the gear selector lever is in the PARK position. The key removal inhibit solenoid is part of the ignition switch.

Push Button Ignition Switch:
The push button ignition switch is used instead of a conventional ignition switch to achieve the various ignition modes. The push button ignition switch is a momentary dual contact switch. Both sets of contacts are normally open and receive the voltage at all times. When the START/STOP button is pressed, the voltage is sent to the BCM, the RFA module, and the PCM to indicate a button press.
The ignition switch has a LED for switch illumination when the backlighting is activated.
OBDII Code B10e7 Mazda - Ignition On Relay - AutoCodes.com

|Need more information with the B10E7 MAZDA code?

Need more information on how to fix the B10E7 MAZDA code?
Get Access to Factory Service Manuals

|Need help with a B10E7 MAZDA code?

Get the B10e7 Mazda code diagnosed by a professional: Find a repair shop in your area

|B10E7 MAZDA code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B10e7 Mazda code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?