AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - B1082 Nissan

B1082 Nissan Code - Front Pre-Tensioner Right Short

- Code Popularity: 4,080 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jan 04, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1082 Nissan Possible Causes

  • Faulty Front Pre-Tensioner Right
  • Front Pre-Tensioner Right harness is open or shorted
  • Front Pre-Tensioner Right circuit poor electrical connection

|How do I Fix the Code B1082 Nissan?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Nissan have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1082 Nissan?

Labor: 1.0

The cost of diagnosing the B1082 Nissan code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1082 Nissan Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1082 Nissan Description

In the case of a frontal collision that exceeds specified impact level, the diagnosis sensor unit detects the deceleration caused by the collision. If restrains the passenger with seat belt easing the stress on passengers chest with load limiter.
The restraint system for front seat occupant consists of the pre-tensioner mechanism and load limiter mechanism.

OBDII Code B1082 Nissan - Front Pre-Tensioner Right Short - AutoCodes.com
B1082 Nissan Code - Front Pre-Tensioner Right Short

|Need More Information on the B1082 Nissan Code?

Need more information on how to fix the B1082 Nissan code? Get Access to Factory Service Manuals

|Need Help with the B1082 Nissan Code?

Get the B1082 Nissan code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1082 Nissan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1082 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks