AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Infiniti - B1071 INFINITI

B1071 INFINITI Code - Assist Air Bag Module Short

- Code Popularity: 938 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Feb 11, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|B1071 INFINITI code possible causes

  • Faulty Assist Air Bag Module
  • Assist Air Bag Module harness is open or shorted
  • Assist Air Bag Module circuit poor electrical connection
  • Faulty Diagnosis Sensor Unit

|How do I fix code B1071 INFINITI code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|Cost of diagnosing B1071 INFINITI code

Labor: 1.0

The cost of diagnosing the B1071 INFINITI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are B1071 INFINITI code possible symptoms?

  • Air Bag Warning Light ON

|B1071 INFINITI code description

In the case of a frontal collision whose acceleration exceeds the specified level, the ignition materials are ignited by the electric ignition system. The system burns and introduces the chemical reaction of gas generating materials to generate hot gases that flow into the air bag through a filter and expand the bag.
The front passenger air bag module mainly consists of air bag and inflator which inflates the air bag.

OBDII Code b1071 infiniti - Assist Air Bag Module Short - AutoCodes.com
B1071 INFINITI Code - Assist Air Bag Module Short

|Need more information with the B1071 INFINITI code?

Need more information on how to fix the B1071 INFINITI code? Get Access to Factory Service Manuals

|Need help with a B1071 INFINITI code?

Get the b1071 infiniti code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|B1071 INFINITI code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the b1071 infiniti code? Have you replaced any parts?
Any information is appreciated. Thanks