B1048 MERCURY - Brake Fluid Level Switch Low Fluid Level
B1048 MERCURY Possible Causes
- Faulty Brake Fluid Level Switch
- Brake Fluid Level Switch harness is open or shorted
- Brake Fluid Level Switch circuit poor electrical connection
- Faulty Electronic Brake Distribution (EBD)
How do I fix code B1048 MERCURY?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the B1048 MERCURY code
Labor: 1.0The cost of diagnosing the B1048 MERCURY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
B1048 MERCURY DescriptionThe Instrument Panel Cluster (IPC) uses 3 basic messaged inputs to control the brake warning indicator. The first two are the parking brake warning indicator switch and the brake fluid level switch. The third is for the Electronic Brake Distribution (EBD) function controlled by the ABS module. The parking brake warning indicator switch and the brake fluid level switch status are sent from the Body Control Module (BCM) over the High Speed Controller Area Network (HS-CAN). The EBD message is sent from the ABS module over the HS-CAN.
The parking brake warning indicator switch is hardwired to the BCM through a single signal circuit while using a separate ground to control the input. The brake fluid level switch is hardwired to the BCM through separate signal and return circuits while using a separate ground to control the input.
The BCM provides a reference voltage to both the parking brake warning indicator switch and the brake fluid level switch. When the parking brake is applied, the parking brake warning indicator switch closes to ground, pulling the parking brake signal circuit low. When a low brake fluid level condition exists, the brake fluid level switch closes to ground, pulling the signal and return circuits low. If the brake fluid level switch is disconnected, the BCM reference voltage sent to the brake fluid level switch is sent high and the BCM sets DTC B1048:7B. When the BCM detects either the brake fluid level signal or the parking brake signal circuits low, or the brake fluid level signal and return circuit high, the BCM sends the IPC a brake warning indicator on request.
When the ABS module detects a base brake system concern or other ABS related concerns that affect the EBD function, the ABS module sends a brake warning indicator on request to the IPC to illuminate the brake warning indicator and the ABS warning indicator.
More InformationNeed more information on how to fix the B1048 MERCURY code?
Get Access to Factory Service Manuals
Need more help?Get the B1048 Mercury code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1048 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks