B1034 NISSAN Code - Crash Zone Sensor
|B1034 NISSAN code possible causes
- Faulty Crash Zone Sensor
- Crash Zone Sensor harness is open or shorted
- Crash Zone Sensor circuit poor electrical connection
- Faulty Air Bag Diagnosis Sensor Unit
|How do I fix the B1034 NISSAN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the B1034 NISSAN code
Labor: 1.0The cost of diagnosing the B1034 NISSAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1034 NISSAN code possible symptoms?
- Air Bag Warning Light ON
|B1034 NISSAN code descriptionThe Crash Zone Sensor is the main “G” sensor that generates a signal voltage when it detects deceleration beyond the specified level caused by a frontal vehicle collision.
When the Air Bag Diagnosis Sensor Unit (ACU) defines both signal voltage of the “G” sensor and the safing sensor to be that of a collision which exceeds a specified level, the driving circuit switches on and feeds the electric ignitor of both driver and passenger air bags and pre-tensioner seat belt.
The Crash Zone Sensor has an integrated type of the “G” sensor element for frontal collision with output terminals for signal voltage.
|Need more information with the B1034 NISSAN code?Need more information on how to fix the B1034 NISSAN code?
Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
|Need help with a B1034 NISSAN code?Get the B1034 Nissan code diagnosed by a professional: Find a repair shop in your area
|B1034 NISSAN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1034 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks