B1007 GMC - EEPROM Write Error
B1007 GMC Possible Causes
- Faulty Control Module
- Control Module harness is open or shorted
- Control Module circuit poor electrical connection
How do I fix code B1007 GMC?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the B1007 GMC code
Labor: 1.0The cost of diagnosing the B1007 GMC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
B1007 GMC DescriptionEEPROM write error detection is internal. No external circuits are involved. For Diagnostic Trouble Code (DTC) to set, the microprocessor must run the program to detect a write error whenever it writes to EEPROM. The program runs even if the voltage is out of the valid operating range.
The microprocessor first writes information to a cell or address in EEPROM. The microprocessor then reads information and compares to what was sent to the address. If they do not match after three consecutive attempts, the microprocessor will set DTC B1007. When DTC is set, the microprocessor finds another area to write information to. This new area becomes a permanent area for the storage of this information. DTC will clear when the microprocessor makes a successful write to EEPROM.
More InformationNeed more information on how to fix the B1007 GMC code?
Get Access to Factory Service Manuals
Need more help?Get the B1007 Gmc code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1007 Gmc code? Have you replaced any parts?
Any information is appreciated. Thanks