AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - B1007 Ford

B1007 Ford Code - High-Beam Headlamp Switch Component Failure

- Code Popularity: 2,556 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B1007 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty High-Beam Headlamp Switch
  • High-Beam Headlamp Switch harness is open or shorted
  • High-Beam Headlamp Switch circuit poor electrical connection
  • Faulty Steering Column Control Module (SCCM)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC B1007 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B1007 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B1007 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B1007 Ford Description

The Steering Column Control Module (SCCM) monitors input from the multifunction and headlamp switches. When the headlamp switch is in the HEADLAMPS ON position and the multifunction switch is placed in the HIGH BEAM position, the SCCM sends a message to the Body Control Module (BCM) over the High Speed Controller Area Network (HS-CAN), indicating a high beam request. The BCM then provides voltage to the high beams. The BCM provides an overload protection of the high beam output circuits. When an excessive current draw is detected, the BCM disables the affected high beam circuit driver. The Instrument Panel Cluster (IPC) also receives a message over the HS-CAN to illuminate the high beam indicator when a request for the high beams is received. This DTC sets when the SCCM detects a fault from the multifunction switch input.

OBDII Code B1007 Ford - High-Beam Headlamp Switch Component Failure - AutoCodes.com
B1007 Ford Code - High-Beam Headlamp Switch Component Failure

Need More Information on the Code?

Need more information on how to fix the B1007 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1007 Ford code diagnosed by a professional: Find a repair shop in your area

Code B1007 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1007 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks