B097C - Power Mode Run/Start Indicator

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

B097C Possible Causes

  • Faulty Ignition Mode Switch
  • Ignition Mode Switch harness is open or shorted
  • Ignition Mode Switch circuit poor electrical connection
  • Faulty Body Control Module (BCM)

How do I fix code B097C

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

B097C Tech Notes

B097C 01: Power Mode Run/Start Circuit Indicator Short to Battery
B097C 02: Power Mode Run/Start Circuit Indicator Short to Ground
B097C 04: Power Mode Run/Start Indicator Circuit Open

Cost of diagnosing the B097C code

    Labor: 1.0

    The cost of diagnosing the B097C code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

B097C Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

B097c Description

The Ignition Mode Switch has 2 LED's that indicate the vehicle power mode. When the vehicle is in the off mode, both LED's will be off. Pressing the ignition mode switch button once (without the brake pedal applied), the vehicle enters the accessory mode and the amber LED (ACC) will illuminate. The accessory mode has a 5 minute timeout to reduce battery drain. Pressing the ignition mode switch button a second time (without the brake pedal applied), the vehicle enters the run/start mode (without the engine running) and the green LED (Run/Start) will illuminate. Pressing and holding the push button start switch for at least 5 seconds will place the vehicle in run/start mode (without the vehicle running) and the green LED (Run/Start) will illuminate. With the ignition off (with the brake pedal applied), pressing the ignition mode switch button once, the vehicle will enter run/start mode and the green LED (run/start) will illuminate. This will start the engine. Both LED's have the voltage supplied from the Body Control Module (BCM). The ignition mode switch sends the ignition mode switch status to the Passive Entry Passive Start Module (PEPS) and to the BCM. The PEPS module sends a redundant signal to the BCM with the ignition mode switch status.
OBDII Code B097c - Power Mode Run/Start Indicator - AutoCodes.com

B097C More Information

Need more information on how to fix the B097C code?
Get Access to Factory Service Manuals

B097C Information for specific makes

Need more help?

Get the B097c code diagnosed by a professional: Find a repair shop in your area

Related Information

B097C Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B097c code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧