B067A:01 Code - Rollover Protection OFF Indicator Circuit Short to Battery
Quick Answer
If the vehicle is equipped with a rollover protection disable switch, when pressed and held, will disable rollover protection and the inflatable restraint sensing and diagnostic module will illuminate the rollover protection disabled indicator. Common causes include Faulty Rollover Protection OFF Indicator, Rollover Protection OFF Indicator harness is open or shorted, Rollover Protection OFF Indicator circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- B067A:01 indicates Rollover Protection OFF Indicator Circuit Short to Battery.
- Common causes
- Common causes include Faulty Rollover Protection OFF Indicator, Rollover Protection OFF Indicator harness is open or shorted, Rollover Protection OFF Indicator circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code B067A:01 Description
What are the Possible Causes of the DTC B067A:01?
- Faulty Rollover Protection OFF Indicator
- Rollover Protection OFF Indicator harness is open or shorted
- Rollover Protection OFF Indicator circuit poor electrical connection
- Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)
How to Fix the DTC B067A:01?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
B067A:02 Rollover Protection OFF Indicator Circuit Short to Ground
B067A:04 Rollover Protection OFF Indicator Circuit Open
B067A:05 Rollover Protection OFF Indicator Circuit High Voltage/Open
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B067A:01 code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the B067A:01 code?
Need more information on how to fix the B067A:01 code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the B067A:01 code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Frequently Asked Questions about B067A:01 Code
No Frequently Asked Questions about B067A:01 Code found.
Discuss the causes and fixes for B067A:01 OBDII Code
Code B067A:01 comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
