Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
A broken or damaged air temperature door and or actuator can cause this Diagnostic Trouble Code (DTC) to set by allowing the actuator shaft to rotate completely to its internal stop (overtravel condition). Internal stops are outside the working range of feedback potentiometers 0-250 count. If the condition exists, wiggle wires and connectors and check for poor connections.
The cost of diagnosing the B0237 GMC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Stepper motors are used for temperature regulation, air distribution control and recirculation door control. With the switches and dials on the HVAC controls, air temperature door position, mode door position and recirculation door position can be selected. The selected values are passed to the Heating, Ventilation, and Air Conditioning (HVAC) Control Module via serial data. The HVAC control module supplies a 12 V reference voltage to the stepper motors and energizes the 4 stepper motor coils with a pulsed ground signal. The stepper motors move the appropriate doors into the calculated positions, in order to reach the desired positions.
Need more information on how to fix the B0237 GMC code? Get Access to Factory Service Manuals
Get the b0237 gmc code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the b0237 gmc code? Have you replaced any parts?
Any information is appreciated. Thanks