AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Scion - B0137 SCION

B0137 SCION Code - Short To Ground Left Seat Belt Pretensioner Squib Circuit

Updated Mar 10, 2021
- Code Popularity: 737 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

|B0137 SCION code possible causes

  • Faulty Left Seat Belt Pretensioner
  • Left Seat Belt Pretensioner harness is open or shorted
  • Left Seat Belt Pretensioner circuit poor electrical connection
  • Faulty Air Bag Control Module

|How do I fix code B0137 SCION code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing B0137 SCION code

Labor: 1.0

The cost of diagnosing the B0137 SCION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are B0137 SCION code possible symptoms?

  • Air Bag Warning Light ON

|B0137 SCION code description

The left seat belt pretensioner squib circuit consists of the air bag center sensor and right seat belt pretensioner. The squib circuit causes the left seat belt pretensioner to deploy when deployment conditions are satisfied. The Air Bag Control Module monitors the Left Seat Belt Pretensioner. The Air Bag Control Module sets the OBDII code when the Left Seat Belt Pretensioner is not to factory specifications.

OBDII Code B0137 Scion - Short To Ground Left Seat Belt Pretensioner Squib Circuit - AutoCodes.com
Short To Ground Left Seat Belt Pretensioner Squib Circuit

|Need more information with the B0137 SCION code?

Need more information on how to fix the B0137 SCION code?
Get Access to Factory Service Manuals

|Need help with a B0137 SCION code?

Get the B0137 Scion code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|B0137 SCION code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0137 Scion code? Have you replaced any parts?
Any information is appreciated. Thanks