AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Scion - B0113 Scion

B0113 Scion Code - Short To Positive In Right-Side Air Bag Module Squib Circuit

- Code Popularity: 1,263 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jan 07, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B0113 Scion Possible Causes

  • Faulty Right-Side Air Bag Module
  • Right-Side Air Bag Module harness is open or shorted
  • Right-Side Air Bag Module circuit poor electrical connection
  • Faulty Air Bag Control Module

|How do I Fix the Code B0113 Scion?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Scion have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B0113 Scion?

Labor: 1.0

The cost of diagnosing the B0113 Scion code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B0113 Scion Possible Symptoms?

  • Air Bag Warning Light ON

|Code B0113 Scion Description

The side air bag module squib circuit consists of the air bag sensor assembly and side air bag module. The squib circuit causes the side air bag to deploy when deployment conditions are satisfied. The Air Bag Control Module monitors the Right-Side Air Bag Module. The Air Bag Control Module sets the OBDII code when the Right-Side Air Bag Module is not to factory specifications.

OBDII Code B0113 Scion - Short To Positive In Right-Side Air Bag Module Squib Circuit - AutoCodes.com
B0113 Scion Code - Short To Positive In Right-Side Air Bag Module Squib Circuit

|Need More Information on the B0113 Scion Code?

Need more information on how to fix the B0113 Scion code? Get Access to Factory Service Manuals

|Need Help with the B0113 Scion Code?

Get the B0113 Scion code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B0113 Scion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0113 Scion code? Have you replaced any parts?
Any information is appreciated. Thanks