AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - B0094 Nissan

B0094 Nissan Code - Crash Zone Sensor

- Code Popularity: 11,389 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jan 01, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B0094 Nissan Possible Causes

  • Faulty Crash Zone Sensor
  • Crash Zone Sensor harness is open or shorted
  • Crash Zone Sensor circuit poor electrical connection
  • Faulty Air Bag Diagnosis Sensor Unit

|How do I Fix the Code B0094 Nissan?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Nissan have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B0094 Nissan?

Labor: 1.0

The cost of diagnosing the B0094 Nissan code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B0094 Nissan Possible Symptoms?

  • Air Bag Warning Light ON

|Code B0094 Nissan Description

The Crash Zone Sensor is located in front of the radiator. The Crash Zone Sensor sends signals to the Air Bag Diagnosis Sensor Unit during a frontal collision. This sensor may be identified by a yellow connector. The Air Bag Diagnosis Sensor Unit (Air Bag Control Module) monitors the Crash Zone Sensor. The Air Bag Diagnosis Sensor Unit sets the OBDII code when the Crash Zone Sensor is not to factory specifications.

OBDII Code B0094 Nissan - Crash Zone Sensor - AutoCodes.com
B0094 Nissan Code - Crash Zone Sensor

|Need More Information on the B0094 Nissan Code?

Need more information on how to fix the B0094 Nissan code? Get Access to Factory Service Manuals

|Need Help with the B0094 Nissan Code?

Get the B0094 Nissan code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B0094 Nissan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0094 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks