AutoCodes - OBDII Code List - B008F BUICK

B008F BUICK - Rollover Protection Disable Switch

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

B008F BUICK Possible Causes

  • Faulty Rollover Protection Disable Switch
  • Rollover Protection Disable Switch harness is open or shorted
  • Rollover Protection Disable Switch circuit poor electrical connection
  • Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)

How do I fix code B008F BUICK?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the automotive tests and turbo-charge your car repair knowledge

Play Now

Tech Notes

DTC B008F 02 Rollover Protection Disable Switch Circuit Short to Ground
DTC B008F 05 Rollover Protection Disable Switch Circuit High Voltage/Open

Cost of diagnosing the B008F BUICK code

Labor: 1.0

The cost of diagnosing the B008F BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B008F BUICK Description

When the ignition switch is turned to ON, the Inflatable Restraint Sensing and Diagnostic Module (SDM) will perform turn-on test to diagnose critical malfunctions within inflatable restraint sensing and diagnostic module itself. The inflatable restraint sensing and diagnostic module continuously checks the rollover protection disable switch position and circuit defect by letting the regular voltage flow through the rollover protection disable switch circuit and verifying the current.
OBDII Code B008f Buick - Rollover Protection Disable Switch -

More Information

Need more information on how to fix the B008F BUICK code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B008f Buick code diagnosed by a professional: Find a repair shop in your area


Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B008f Buick code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
1=Easy 2=Moderate 3=Hard What is this?