AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Hummer - B0082 Hummer

B0082 Hummer Code - Discard Right Front/Passenger Side Impact Sensor

- Code Popularity: 2,660 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B0082 Hummer?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Discard Right Front/Passenger Side Impact Sensor (SIS)
  • Discard Right Front/Passenger Side Impact Sensor (SIS) harness is open or shorted
  • Discard Right Front/Passenger Side Impact Sensor (SIS) circuit poor electrical connection
  • Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)
⚠ Does your Hummer have Safety Recalls? → Check here

How to Fix the DTC B0082 Hummer?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B0082 Hummer Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B0082 Hummer code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B0082 Hummer Description

The Inflatable Restraint Side Impact Sensor (SIS) utilizes a unidirectional 2-wire circuit. The SIS modulates current on the interface to send ID, State of Health, and deployment commands to the Inflatable Restraint Sensing and Diagnostic Module (SDM). The SDM serves as a power source and a ground for the SIS. When the ignition is turned on and input power from the SDM is first detected, the SIS responds by performing internal diagnostics and sending an ID to the SDM. The SDM considers the ID to be valid if the response time is less than 5 seconds. The SIS continually communicates status messages to the SDM, which determines if a fault is present in the SIS circuit. When a fault is detected, the SDM resets the SIS twice by removing and reapplying power. If the fault is still present, the SDM will set a Diagnostic Trouble Code (DTC).

OBDII Code B0082 Hummer - Discard Right Front/Passenger Side Impact Sensor - AutoCodes.com
B0082 Hummer Code - Discard Right Front/Passenger Side Impact Sensor

Need More Information on the Code?

Need more information on how to fix the B0082 Hummer code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B0082 Hummer code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B0082 Hummer comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0082 Hummer code? Have you replaced any parts?
Any information is appreciated. Thanks