What are the Possible Causes of the DTC B0040 Chevrolet?
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
Faulty Driver's Side Air Bag Module
Driver's Side Air Bag Module harness is open or shorted
Driver's Side Air Bag Module circuit poor electrical connection
⚠ Does your Chevrolet have Safety Recalls? → Check here
How to Fix the DTC B0040 Chevrolet?
Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
Search for B0040 Chevrolet Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B0040 Chevrolet code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Air Bag Warning Light ON
Code B0040 Chevrolet Description
When ignition switch is turned to RUN position, Sensing and Diagnostic Module (SDM) performs tests to diagnose critical internal malfunctions. SDM then performs deployment loop voltage out of range test and deployment loop resistance measurement test. If voltage out of range test detects a short to voltage condition, resistance measurement test will not be performed.
B0040 Chevrolet Code - Driver Side Deployment Loop Resistance Low
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0040 Chevrolet code? Have you replaced any parts? Any information is appreciated. Thanks