| All About OBDII Engine Codes
AutoCodes - Nissan - B0029 Nissan

B0029 Nissan Code - Right Side Curtain Air Bag Module

- Code Popularity: 11,730 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By - Updated Dec 31, 2018
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B0029 Nissan Possible Causes

  • Faulty Right Side Curtain Air Bag Module
  • Right Side Airbag Module harness is open or shorted
  • Right Side Airbag Module circuit poor electrical connection

|How do I Fix the Code B0029 Nissan?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Nissan have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B0029 Nissan?

Labor: 1.0

The cost of diagnosing the B0029 Nissan code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B0029 Nissan Possible Symptoms?

  • Air Bag Warning Light ON

|Code B0029 Nissan Description

The RH side curtain air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the RH side curtain air bag module.

OBDII Code B0029 Nissan - Right Side Curtain Air Bag Module -
B0029 Nissan Code - Right Side Curtain Air Bag Module

|Need More Information on the B0029 Nissan Code?

Need more information on how to fix the B0029 Nissan code? Get Access to Factory Service Manuals

|Need Help with the B0029 Nissan Code?

Get the B0029 Nissan code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B0029 Nissan comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0029 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks