AutoCodes - OBDII Code List - B0019 SATURN

B0019 SATURN - Passenger Frontal Deployment Loop Stage 1

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

B0019 SATURN Possible Causes

  • Faulty Passenger Frontal Module
  • Passenger Frontal Module harness is open or shorted
  • Passenger Frontal Module circuit poor electrical connection
  • Faulty Sensing and Diagnostic Module (SDM)

How do I fix code B0019 SATURN?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Tech Notes

DTC B0019 01 Passenger Frontal Deployment Loop Stage 1 Short to Battery
DTC B0019 02 Passenger Frontal Deployment Loop Stage 1 Short to Ground
DTC B0019 04 Passenger Frontal Deployment Loop Stage 1 Open Circuit
DTC B0019 0D Passenger Frontal Deployment Loop Stage 1 Resistance Above Threshold
DTC B0019 0E Passenger Frontal Deployment Loop Stage 1 Resistance Below Threshold

Cost of diagnosing the B0019 SATURN code

Labor: 1.0

The cost of diagnosing the B0019 SATURN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B0019 SATURN Description

During a side or frontal crash of sufficient force the inflatable restraint Sensing and Diagnostic Module (SDM) will allow current to flow through the deployment loop in order to deploy an inflatable restraint module. There are 2 shorting bars used within the module connector which will short together both high and low circuits, when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing.
OBDII Code B0019 Saturn - Passenger Frontal Deployment Loop Stage 1 - AutoCodes.com

More Information

Need more information on how to fix the B0019 SATURN code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B0019 Saturn code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B0019 Saturn code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Top ⇧