B0019 GMC - Passenger Frontal Deployment Loop Stage 1

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

Possible causes

  • Faulty Passenger Frontal Module
  • Passenger Frontal Module harness is open or shorted
  • Passenger Frontal Module circuit poor electrical connection
  • Faulty Sensing and Diagnostic Module (SDM)

Tech notes

DTC B0019 01 Passenger Frontal Deployment Loop Stage 1 Short to Battery
DTC B0019 02 Passenger Frontal Deployment Loop Stage 1 Short to Ground
DTC B0019 04 Passenger Frontal Deployment Loop Stage 1 Open Circuit
DTC B0019 0D Passenger Frontal Deployment Loop Stage 1 Resistance Above Threshold
DTC B0019 0E Passenger Frontal Deployment Loop Stage 1 Resistance Below Threshold

Possible symptoms

  • Air Bag Warning Light ON

B0019 Gmc Description

During a side or frontal crash of sufficient force the inflatable restraint Sensing and Diagnostic Module (SDM) will allow current to flow through the deployment loop in order to deploy an inflatable restraint module. There are 2 shorting bars used within the module connector which will short together both high and low circuits, when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing.
OBDII Code B0019 Gmc - Passenger Frontal Deployment Loop Stage 1 - AutoCodes.com

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B0019 Gmc code diagnosed by a professional: Find a repair shop in your area

Related Information

B0019 GMC Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B0019 Gmc code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧