AutoCodes - OBDII Code List - B0018 BUICK

B0018 BUICK - Passenger Frontal Deployment Loop Voltage Out of Range

Repair Importance Level: 3/3

Repair Difficulty Level: 3/3 What is this?

Table of contents

Possible Causes
How To Fix
Cost to Diagnose
Description
Comments
Add Comment

B0018 BUICK Possible Causes

What does this mean?

Faulty Inflatable Restraint Instrument Panel
Inflatable Restraint Instrument Panel harness is open or shorted
Inflatable Restraint Instrument Panel circuit poor electrical connection
Faulty Sensing and Diagnostic Module (SDM)

How do I fix code B0018 BUICK?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Cost of diagnosing the B0018 BUICK code

Labor: 1.0

The cost of diagnosing the B0018 BUICK code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

Air Bag Warning Light ON

B0018 BUICK Description

The Inflatable Restraint Instrument Panel (I/P) module deployment loop consists of a dual stage I/P module, I/P module high control, and I/P module low control circuits for both stages 1 and 2. There are 2 shorting bars used within the I/P module connector which will short together the I/P module high and I/P module low control circuits for both stages 1 and 2 when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing. When the ignition is turned ON, the inflatable restraint Sensing and Diagnostic Module (SDM) performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, a Diagnostic Trouble Code (DTC) will be stored in memory.

OBDII Code B0018 Buick - Passenger Frontal Deployment Loop Voltage Out of Range - AutoCodes.com

More Information

Need more information on how to fix the B0018 BUICK code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B0018 Buick code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B0018 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks

Top ⇧