B0005 MERCURY - Collapsible Steering Column Deployment Control
B0005 MERCURY Possible Causes
- Faulty Deployable Steering Column
- Deployable Steering Column harness is open or shorted
- Deployable Steering Column circuit poor electrical connection
- Faulty Restraint Control Module (RCM)
First diagnose B0005 MERCURY code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
B0005 MERCURY Tech NotesB0005:12 Collapsible Steering Column Deployment Control: Circuit Short to Battery
B0005:13 Collapsible Steering Column Deployment Control: Circuit Open
B0005:1A Collapsible Steering Column Deployment Control: Circuit Resistance Below Threshold
B0005:2B Collapsible Steering Column Deployment Control: Signal Cross Coupled
B0005:4A Collapsible Steering Column Deployment Control: Incorrect Component Installed
Cost of diagnosing the B0005 MERCURY code
Labor: 1.0The cost of diagnosing the B0005 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
B0005 MERCURY Possible Symptoms
- Air Bag Warning Light ON
B0005 Mercury DescriptionThe Restraint Control Module (RCM) analyzes the deployment loop resistance to determine if a fault exists. The value displayed in the Parameter Identification (PID) is the deployment loop resistance measured by the RCM. If the value displayed is lower or higher than the desired range, the RCM can set a Diagnostic Trouble Code (DTC). As the deployment loop resistance drifts farther outside the desired range, the chance for a DTC increases. Small variations in resistance can occur due to the effect of road vibrations on terminal fit. Crimps and terminals can be affected by stress and harness movement and can cause an increase in resistance due to wire strain. These variables can result in an intermittent fault. For this reason, the test requires the Parameter Identification (PID) value to be within the desired range before the fault is considered repaired, regardless if the module is reporting an on-demand DTC at the time of diagnosis. Following this direction helps make sure that minor changes in resistance do not create a repeat concern. This test uses the process of elimination to diagnose each part of the deployment loop circuit including Wiring, Connections, Deployable Steering Column, and RCM.
B0005 MERCURY More InformationNeed more information on how to fix the B0005 MERCURY code?
Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Need more help?Get the B0005 Mercury code diagnosed by a professional: Find a repair shop in your area
B0005 MERCURY CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B0005 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks