B0002 NISSAN Code - Driver Air Bag Module
|B0002 NISSAN code possible causes
- Faulty Driver Air Bag Module
- Driver Air Bag Module harness is open or shorted
- Driver Air Bag Module circuit poor electrical connection
- Faulty Spiral Cable
- Faulty Air Bag Diagnosis Sensor
|How do I fix the B0002 NISSAN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the B0002 NISSAN code
Labor: 1.0The cost of diagnosing the B0002 NISSAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B0002 NISSAN code possible symptoms?
- Air Bag Warning Light ON
|B0002 NISSAN code descriptionThe Driver Air Bag Module is dual stage and is wired to the Air Bag Diagnosis Sensor unit through the Spiral Cable. The Air Bag Diagnosis Sensor unit will monitor for opens and shorts in detected lines to the Driver Air Bag Module including the spiral cable. The Air Bag Sensor Unit (Air Bag Control Module) monitors the Driver Air Bag Module. The Air Bag Sensor Unit sets the OBDII code when the Driver Air Bag Module is not to factory specifications.
|Need more information with the B0002 NISSAN code?Need more information on how to fix the B0002 NISSAN code? Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
|Need help with a B0002 NISSAN code?Get the B0002 Nissan code diagnosed by a professional: Find a repair shop in your area
|B0002 NISSAN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0002 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks