AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Chrysler - P1494 Chrysler

P1494 Chrysler Code - EVAP Leak Detection Pump Pressure Switch Condition

- Code Popularity: 57,531 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1494 Chrysler?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Leak Detection Pump (LDP)
  • Leak Detection Pump (LDP) harness is open or shorted
  • Leak Detection Pump (LDP) poor electrical connection
⚠ Does your Chrysler have Safety Recalls? → Check here

How to Fix the DTC P1494 Chrysler?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1494 Chrysler Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1494 Chrysler code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Malfunction is detected when the Powertrain Control Module (PCM) detected the leak detection pump switch did not change after the solenoid was energized

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • A noticeable fuel odor may result from fuel vapor release

Code P1494 Chrysler Description

The Evaporative emissions system is designed to prevent the escape of fuel vapors from the fuel system. Leaks in the system ca allow vapors to escape into the atmosphere. The leak detection system tests for EVAP system leaks and blockage.
During the self-diagnostics, the Powertrain Control Module (PCM) first checks the Leak Detection Pump (LDP) for electrical and mechanical faults. If the first checks pass, the PCM then uses the LDP to seal the vent valve and pump air into the system to pressurize it. If a leak is present, the PCM will continue pumping the LDP to replace the air that leaks out. The PCM determines the size of the leak based on how fast/long it must pump the LDP as it tries to maintain pressure in the system.

OBDII Code P1494 Chrysler - EVAP Leak Detection Pump Pressure Switch Condition - AutoCodes.com
P1494 Chrysler Code - EVAP Leak Detection Pump Pressure Switch Condition

Need More Information on the Code?

Need more information on how to fix the P1494 Chrysler code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1494 Chrysler code diagnosed by a professional: Find a repair shop in your area

Code P1494 Chrysler comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1494 Chrysler code? Have you replaced any parts?
Any information is appreciated. Thanks