AutoCodes - Infiniti - P1136 2005 INFINITI G35

P1136 2005 INFINITI G35 Code - Intake Valve Timing Control Solenoid Valve Circuit Bank 2

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P1136 2005 INFINITI G35 code possible causes

  • Faulty Intake Valve Timing Control Solenoid Bank 2
  • Intake Valve Timing Control Solenoid Bank 2 harness is open or shorted
  • Intake Valve Timing Control Solenoid Bank 2 circuit poor electrical connection

|How do I fix the P1136 2005 INFINITI G35 code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P1136 2005 INFINITI G35 code tech notes

Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the valve, change the engine oil and filter and reset the engine code. If the code comes back you can remove the Intake valve timing control solenoid and clean it with brake cleaner.

|Cost of diagnosing the P1136 2005 INFINITI G35 code

Labor: 1.0

The cost of diagnosing the P1136 2005 INFINITI G35 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P1136 2005 INFINITI G35 code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible engine lack/loss of power
  • Possible engine rough idle

|P1136 2005 INFINITI G35 code description

The intake valve timing control solenoid valve is activated by ON/OFF pulse duty (ratio) signals from the Engine Control Module (ECM). The intake valve timing control solenoid valve changes the oil amount and direction of flow through the intake valve timing control unit or stops oil flow.
The longer pulse width advances the valve angle. The shorter pulse width retards the valve angle.
When ON and OFF pulse widths become equal, the solenoid valve stops oil pressure flow to fix the intake valve angle at the control position.
The Diagnostic Trouble Code (DTC) when an improper voltage is sent to the ECM through the intake valve timing control solenoid valve.
OBDII Code P1136 2005 Infiniti G35 - Intake Valve Timing Control Solenoid Valve Circuit Bank 2 - AutoCodes.com

|Need more information with the P1136 2005 INFINITI G35 code?

Need more information on how to fix the P1136 2005 INFINITI G35 code?
Get Access to Factory Service Manuals

|Need help with a P1136 2005 INFINITI G35 code?

Get the P1136 2005 Infiniti G35 code diagnosed by a professional: Find a repair shop in your area

|P1136 2005 INFINITI G35 code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1136 2005 Infiniti G35 code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?