AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P1000 Ford

P1000 Ford Code - On Board Diagnostic System Readiness Test Not Complete

- Code Popularity: 366,835 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jul 21, 2022
Share on Facebook   Share on Twitter   Share on Linkedin

|Code P1000 Ford Possible Causes

  • The vehicle is new from the factory.
  • Battery or Powertrain Control Module (PCM) had recently been disconnected.
  • An OBD monitor failure occurred before completion of an OBD drive cycle.
  • PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.

|How do I Fix the Code P1000 Ford?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Ford have Safety Recalls? → Check here

|Code P1000 Ford Tech Notes

This code just means that the Powertrain Control Module (PCM) didn't complete a full diagnosis cycle, and is set when the battery has been disconnected, codes have been cleared, or sometimes even when the vehicle has been towed. No scanner is necessary to clear the code, driving the vehicle for a few minutes (sometimes more) to complete the diagnosis cycle will clear the code. Clearing the code will reset the light unless other codes are present.





User Submitted Video

|What is the Cost to Diagnose the Code P1000 Ford?

Labor: 1.0

The cost of diagnosing the P1000 Ford code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code P1000 Ford Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|Code P1000 Ford Description

The On-Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check. If Diagnostic Trouble Code (DTC) P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.

OBDII Code P1000 Ford - On Board Diagnostic System Readiness Test Not Complete - AutoCodes.com
P1000 Ford Code - On Board Diagnostic System Readiness Test Not Complete

|Need More Information on the P1000 Ford Code?

Need more information on how to fix the P1000 Ford code? Get Access to Factory Service Manuals

|Need Help with the P1000 Ford Code?

Get the P1000 Ford code diagnosed by a professional: Find a repair shop in your area

|Code P1000 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1000 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks