AutoCodes - OBDII Code List - P0888 DODGE

P0888 DODGE - Transmission Relay Always Off

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

P0888 DODGE Possible Causes

  • Faulty Transmission Control Relay
  • Transmission Control Relay harness is open or shorted
  • Transmission Control Relay circuit poor electrical connection
  • Faulty Transmission Solenoid/Pressure Switch Assembly

How do I fix code P0888 DODGE?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Connect Your Car To The Future

Tech Notes

Inadequate Transmission Control Relay Output voltage can also cause DTCs P0846, P0869, P0871, P0876 or P0988 to set. This does not indicate an internal transmission or solenoid TRS problem. Repairing the P0888 fault should also eliminate the related DTCs.

Dodge Caravan




User Submitted Video

Cost of diagnosing the P0888 DODGE code

Labor: 1.0

The cost of diagnosing the P0888 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

This code is set when less than 3 volts are present at the Transmission Control Relay Output (switched battery) terminals at the Powertrain Control Module (PCM), when the PCM is energizing the relay.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0888 DODGE Description

The transmission control relay is used to supply power to the solenoid pack when the transmission is in normal operating mode. When the relay is off, no power is supplied to the solenoid pack and the transmission is in Limp-in mode. The relay output is fed back to the Powertrain Control Module (PCM). It is referred to as the Transmission Control Relay Output circuit or switched battery.
After a controller reset (ignition key turned to the run position or after cranking engine), the controller energizes the relay. Prior to this the PCM verifies that the contacts are open by checking for no voltage at the switched battery terminals. After the relay is energized, the PCM monitors the terminals to verify that the voltage is greater than 3 volts.
OBDII Code P0888 Dodge - Transmission Relay Always Off - AutoCodes.com

More Information

Need more information on how to fix the P0888 DODGE code?
Get Access to Factory Service Manuals

Need more help?

Get the P0888 Dodge code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0888 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧