AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Dodge - P0731 DODGE

P0731 DODGE Code - Gear Ratio Error In First Gear

- Code Popularity: 57,267 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jul 01, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|P0731 DODGE code possible causes

  • Low transmission fluid level
  • Dirty transmission fluid
  • Shift solenoids
  • Transmission mechanical problems
  • Transmission hydraulic control circuit

|How do I fix code P0731 DODGE code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|P0731 DODGE code tech notes

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.

There is a Factory Service Bulletin for the Dodge following models:
2005-2006 Dodge Ram Truck
2005-2006 Dodge Durango
2005-2006 Dodge Dakota
Dodge Factory Service Bulletin OBDII Code P0731

|Cost of diagnosing P0731 DODGE code

Labor: 1.0

The cost of diagnosing the P0731 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the P0731 DODGE code detected?

The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions

|What are P0731 DODGE code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

|P0731 DODGE code description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (1st) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

OBDII Code p0731 dodge - Gear Ratio Error In First Gear - AutoCodes.com
P0731 DODGE Code - Gear Ratio Error In First Gear

|Need more information with the P0731 DODGE code?

Need more information on how to fix the P0731 DODGE code? Get Access to Factory Service Manuals

|Need help with a P0731 DODGE code?

Get the p0731 dodge code diagnosed by a professional: Find a repair shop in your area

|P0731 DODGE code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the p0731 dodge code? Have you replaced any parts?
Any information is appreciated. Thanks