Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
To diagnose the P0717 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
Diagnostic Trouble Code (DTC) P0717 is detected when TCM or ECM receives no signal from the sensor.
The Input Speed Sensor 1 is one of the two hall effect speed sensors that are used by the Transmission Control Module (TCM) to calculate the transmissions turbine speed. Since the turbine speed could not be measured directly, two of the drive elements are measured. Two input speed sensors are required because both elements are not active in all gears.
Need more information on how to fix the P0717 Jeep code? Get Access to Factory Service Manuals
Get the P0717 Jeep code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0717 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks