P0366 FORD - Camshaft Position Sensor 'B' Circuit Range/Performance Bank 1

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P0366 FORD Possible Causes

  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery

First diagnose P0366 FORD code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the P0366 FORD code

    Labor: 1.0

    The cost of diagnosing the P0366 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0366 FORD code detected?

The camshaft position sensor signal sent to the Engine Control Module(ECM) during the first few seconds of engine cranking is out of range.

P0366 FORD Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

P0366 Ford Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module (ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.

When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

OBDII Code P0366 Ford - Camshaft Position Sensor 'B' Circuit Range/Performance Bank 1 - AutoCodes.com

P0366 FORD More Information

Need more information on how to fix the P0366 FORD code?
Get Access to Factory Service Manuals

Need more help?

Get the P0366 Ford code diagnosed by a professional: Find a repair shop in your area

Related Information

P0366 FORD Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0366 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧