AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P0130 2008 Nissan Rogue

P0130 2008 Nissan Rogue Code - Air Fuel Ratio Circuit Bank 1 Sensor 1

- Code Popularity: 4,397 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
By AutoCodes.com - Updated Jun 14, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|Code P0130 2008 Nissan Rogue Possible Causes

  • Faulty Air fuel ratio (A/F) sensor bank 1 sensor 1
  • Air fuel ratio (A/F) sensor bank 1 sensor 1 harness is open or shorted
  • Air fuel ratio (A/F) sensor bank 1 sensor 1 circuit poor electrical connection
  • Inappropriate fuel pressure
  • Faulty fuel injectors
  • Intake air leaks may be faulty
  • Exhaust gas leaks

|How do I Fix the Code P0130 2008 Nissan Rogue?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Nissan have Safety Recalls? → Check here

|Code P0130 2008 Nissan Rogue Tech Notes

Replacing the Air fuel ratio (A/F) sensor bank 1 sensor 1 usually takes care of the problem.

|What is the Cost to Diagnose the Code P0130 2008 Nissan Rogue?

Labor: 1.0

The cost of diagnosing the P0130 2008 Nissan Rogue code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the Code P0130 2008 Nissan Rogue Detected?

The Air Fuel Ratio (A/F) signal computed by Engine Control Module (ECM) from the A/F sensor 1 signal is constantly in the range other than approx. 1.5V.

|What are Code P0130 2008 Nissan Rogue Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

|Code P0130 2008 Nissan Rogue Description

The Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance. An electronic circuit controls the pump current through the oxygen pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800°C (1,292 - 1,472°F).

OBDII Code P0130 2008 Nissan Rogue - Air Fuel Ratio Circuit Bank 1 Sensor 1 - AutoCodes.com
P0130 2008 Nissan Rogue Code - Air Fuel Ratio Circuit Bank 1 Sensor 1

|Need More Information on the P0130 2008 Nissan Rogue Code?

Need more information on how to fix the P0130 2008 Nissan Rogue code? Get Access to Factory Service Manuals

|Need Help with the P0130 2008 Nissan Rogue Code?

Get the P0130 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area

|Code P0130 2008 Nissan Rogue comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0130 2008 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks