AutoCodes - Jeep - P0108 JEEP

P0108 JEEP Code - Manifold Absolute Pressure Sensor Circuit High

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P0108 JEEP code possible causes

  • Faulty Manifold Absolute Pressure (MAP) Sensor
  • Manifold Absolute Pressure Sensor harness is open or shorted
  • Manifold Absolute Pressure Sensor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

|How do I fix the P0108 JEEP code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0108 JEEP code tech notes





User Submitted Video

|Cost of diagnosing the P0108 JEEP code

Labor: 1.0

The cost of diagnosing the P0108 JEEP code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P0108 JEEP code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine rough idle
  • Engine hesitation

|P0108 JEEP code description

The Manifold Absolute Pressure (MAP) Sensor and the Intake Air Temperature (IAT) Sensor are combined into one component. The Powertrain Control Module (PCM) provides a common 5-Volt Supply and sensor ground that is shared by both sensors. Each of these sensors sends feedback to the PCM on its own signal circuit. The MAP sensor is a transducer that varies resistance according to changes in altitude and atmospheric conditions. With the ignition on and the engine not running, the MAP Sensor provides the PCM with the Barometric Pressure reading. When the engine is running, the MAP Sensor signal supplies the PCM with the current air pressure within the Intake Manifold. The IAT Sensor signal supplies the PCM with the temperature of the air entering the Intake Manifold. This information is used by the PCM, along with other inputs to calculate fuel delivery, and timing needs.
The Diagnostic Trouble Code (DTC) will set when the MAP sensor signal voltage is above 4.88 volts for 0.5 seconds.
OBDII Code P0108 Jeep - Manifold Absolute Pressure Sensor Circuit High - AutoCodes.com

|Need more information with the P0108 JEEP code?

Need more information on how to fix the P0108 JEEP code? Get Access to Factory Service Manuals

|P0108 JEEP code information for specific Jeep models

|Need help with a P0108 JEEP code?

Get the P0108 Jeep code diagnosed by a professional: Find a repair shop in your area

|P0108 JEEP code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0108 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?