AutoCodes
 
OBDII Code List
 
P0018 CHEVROLET

P0018 CHEVROLET - Crankshaft Position - Camshaft Position Correlation Bank 2 Sensor 'A'

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

Possible causes

  • Mechanical timing fault
  • Blocked oil passage
  • Low oil level
  • Faulty Intake ('A') Camshaft Position (CMP) Sensor
  • Faulty Crankshaft Position (CKP) Sensor
  • Tech notes

    If this DTC started after recent internal engine repairs, inspect for proper engine mechanical timing. With the camshaft cover removed and the #1 cylinder at top dead center, make sure that the darkened chain links are lined up with the alignment marks on the exhaust and intake cam sprockets.

    There is a factory service bulletin for the following Chevrolet models:
    2008-2012 Chevrolet Captiva
    2008-2012 Chevrolet Equinox
    2008-2012 Chevrolet Malibu
    2009-2012 Chevrolet Traverse
    2010-2012 Chevrolet Camaro
    2012 Chevrolet Impala
    Chevrolet Factory Service Bulletin OBDII Code P0018

    When is the code detected?

    The Powertrain Control Module (PCM) has detected the actual Camshaft Position (CMP) Sensor angle of one camshaft is greater or less than the commanded state.

    Possible symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine hard to start
  • Engine stall while driving
  • P0018 Chevrolet Description

    The Crankshaft Position (CKP) sensor is a permanent magnet generator, known as a variable reluctance sensor. The magnetic field of the sensor is altered by a crankshaft mounted reluctor wheel that has seven machined slots, 6 of which are equally spaced 60 degrees apart. The seventh slot is spaced 10 degrees after one of the 60 degree slots. The CKP sensor produces seven pulses for each revolution of the crankshaft. The pulse from the 10 degree slot is known as the sync pulse. The sync pulse is used to synchronize the coil firing sequence with the crankshaft position. The CKP sensor is connected to the Powertrain Control Module (PCM) by a signal circuit and a low reference circuit.

    The Camshaft Position (CMP) sensor is triggered by a notched reluctor wheel built into the exhaust camshaft sprocket. The CMP sensor provides 6 signal pulses every camshaft revolution. Each notch, or feature of the reluctor wheel is of a different size for individual cylinder identification. This means the CMP and crankshaft position (CKP) signals are pulse width encoded to enable the PCM to constantly monitor their relationship. This relationship is used to determine camshaft actuator position and control its phasing at the correct value. The PCM also uses this signal to identify the compression stroke of each cylinder, and for sequential fuel injection. The CMP sensor is connected to the PCM by a 12-volt, low reference, and signal circuit.

    OBDII Code P0018 Chevrolet - Crankshaft Position - Camshaft Position Correlation Bank 2 Sensor 'A' - AutoCodes.com

    Need more help?

    Get the P0018 Chevrolet code diagnosed by a professional: Find a repair shop in you area

    Related Information

    P0018 CHEVROLET Comments

    Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0018 Chevrolet code? Have you replaced any parts?
    Any information is appreciated. Thanks
    Top ⇧