P0016 KIA - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A'

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

P0016 KIA Possible Causes

  • Faulty Crankshaft Position
  • Crankshaft Position harness is open or shorted circuit.
  • Crankshaft Position circuit poor electrical connector
  • Faulty Camshaft Position
  • Camshaft Position harness is open or shorted circuit.
  • Camshaft Position circuit poor electrical connector
  • Incorrect timing
  • Engine mechanical problems
  • Damaged Engine Control Module (ECM)

How do I fix code P0016 KIA?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

There is a factory service bulletin for the following KIA models:

Rio (JB)
Soul (AM)
Optima (MG)
Rondo (UN)
Forte (TD)
Spectra (LD)
Sportage (KM)
Optima (MG)
Sedona (VQ)
Amanti (GH)
Borrego (HM)
Sedona (VQ)
Sorento (BL)
Borrego (HM)

The bulletin provides information on how to inspect and diagnose problems related to the Oil Control Valve (OCV) used in Constant Variable Valve Timing (CVVT), if at any time the OCV is suspected as the caused of rough idling, poor acceleration, camshaft timing misalignment-related trouble codes, misfire-related trouble codes.

Bulletin: Kia Constant Variable Valve Timing Oil Control Valve Inspection

Cost of diagnosing the P0016 KIA code

Labor: 1.0

The cost of diagnosing the P0016 KIA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

If the relative angle between CKPS and CMPS is out of the threshold value, the ECM determines that a

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

P0016 Kia Description

The Camshaft Position Sensor (CMPS) and the Crankshaft Position Sensor (CKPS) are hall effect type of sensors that generate voltage using a sensor and a target wheel. Then CMPS signal is sent to the Engine Control Module (ECM) and the ECM uses the its signal for synchronizing the firing of sequential fuel injectors. And the Crankshaft Position Sensor (CKPS) is sent to the ECM and it calculates engine RPM by using CKPS's signal and controls the injection duration and the ignition timing.
OBDII Code P0016 Kia - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A' - AutoCodes.com

P0016 KIA More Information

Need more information on how to fix the P0016 KIA code?
Get Access to Factory Service Manuals

Information for specific Kia models

Need more help?

Get the P0016 Kia code diagnosed by a professional: Find a repair shop in your area


Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0016 Kia code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧