AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B1992

B1992 Code - Driver Side Side Mount Airbag Circuit Short To Battery Voltage

- Code Popularity: 3,931 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Aug 03, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1992 Possible Causes

  • Faulty Driver Side Side Mount Airbag
  • Driver Side Side Mount Airbag harness is open or shorted
  • Driver Side Side Mount Airbag circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)

|How do I Fix the Code B1992?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Car have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1992?

Labor: 1.0

The cost of diagnosing the B1992 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1992 Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1992 Description

The Restraints Control Module (RCM) monitors the Driver Side Side Mount Airbag. The RCM sets the OBDII code when the Driver Side Side Mount Airbag is not to factory specifications.

OBDII Code B1992 - Driver Side Side Mount Airbag Circuit Short To Battery Voltage - AutoCodes.com
B1992 Code - Driver Side Side Mount Airbag Circuit Short To Battery Voltage

|Need More Information on the B1992 Code?

Need more information on how to fix the B1992 code? Get Access to Factory Service Manuals

|Information for Specific Makes

  • B1992 Chrysler Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Dodge Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Ford Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 Jeep Right Power Sliding Door Sensor Supply Circuit High
  • B1992 Lincoln Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 Mercury Driver Side Side Mount Airbag Circuit Short To Battery Voltage
  • B1992 RAM Right Power Sliding Door Sensor Supply Circuit High

|Need Help with the B1992 Code?

Get the B1992 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1992 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1992 code? Have you replaced any parts?
Any information is appreciated. Thanks