B115E FORD - Camera Module Bus Signal/Message Failure
- Faulty Video Camera
- Video Camera harness is open or shorted
- Video Camera circuit poor electrical connection
- Anti-Lock Brake System (ABS) Warning Light ON
- Engine Light ON (or Service Engine Soon Warning Light)
B115e Ford DescriptionWhen the ignition switch is in the RUN position, the video camera receives voltage. With the gear selector in reverse, the Accessory Protocol Interface Module (APIM) receives the reverse signal from the Body Control Module (BCM) over the Medium Speed Controller Area Network (MS-CAN), enabling the system. The video camera also receives the reverse signal message from BCM over the Local Interconnect Network (LIN). The LIN is a dedicated single wire communication line that sends and receives network messages from the BCM to the video camera. A pair of shielded wires carries the video signal from the video camera to the APIM . The APIM sends the video signal to the Front Display Interface Module (FDIM) and displays a video image of the area behind the vehicle. An on-demand DTC that sets in the BCM when there is a LIN communication fault from the video camera.
Need more help?Get the B115e Ford code diagnosed by a professional: Find a repair shop in your area
B115E FORD CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B115e Ford code? Have you replaced any parts?
Any information is appreciated. Thanks