B1086 FORD - Air Distribution Damper Motor Circuit
B1086 FORD Possible Causes
- Faulty Air Distribution Damper Motor
- Air Distribution Damper Motor harness is open or shorted
- Air Distribution Damper Motor circuit poor electrical connection
- Faulty Heating, Ventilation, and Air Conditioning (HVAC) Module
How do I fix code B1086 FORD?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
B1086:12 - Air Distribution Damper Motor: Circuit Short to Battery
B1086:13 - Air Distribution Damper Motor: Circuit Open
Cost of diagnosing the B1086 FORD code
Labor: 1.0The cost of diagnosing the B1086 FORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
B1086 FORD DescriptionTo rotate the defrost/panel/floor mode door actuator, the Heating, Ventilation, and Air Conditioning (HVAC) Module supplies voltage and ground to the defrost/panel/floor mode door actuator motor through the actuator motor circuits. To reverse the defrost/panel/floor mode door actuator rotation, the HVAC module reverses the voltage and ground circuits.
The defrost/panel/floor mode door actuator feedback resistor is supplied a 5-volt reference voltage and ground from the HVAC module. The HVAC module measures the resistance on the defrost/panel/floor mode door actuator feedback circuit to determine the defrost/panel/floor mode door actuator position by the position of the actuator feedback resistor wiper arm.
During an actuator calibration cycle, the HVAC module drives the defrost/panel/floor mode door until the door reaches both internal stops in the HVAC case. If the defrost/panel/floor mode door is temporarily obstructed or binding during a calibration cycle, the HVAC module may interpret this as the actual end of travel for the door. When this condition occurs and the HVAC module commands the actuator to its end of travel, the airflow may not be from the expected outlets.
More InformationNeed more information on how to fix the B1086 FORD code?
Get Access to Factory Service Manuals
Need more help?Get the B1086 Ford code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1086 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks