AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B0976

B0976 Code - Off Indicator Control Circuit

- Code Popularity: 1,287 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B0976?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Ignition Mode Switch
  • Ignition Mode Switch harness is open or shorted
  • Ignition Mode Switch circuit poor electrical connection
  • Faulty Body Control Module (BCM)
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC B0976?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B0976 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B0976 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B0976 Description

The Ignition Mode Switch has 3 LEDs that indicate the vehicle power mode. When the vehicle is in the Off mode, the Off LED may illuminate. Pressing the lower button of the ignition mode switch, the vehicle enters the accessory mode and ACC LED will illuminate. Keeping the lower button pressed for about 5-6 seconds, the vehicle enters run mode with the engine off and the START LED will illuminate. All these LEDs have the voltage supplied from the Body Control Module (BCM) through the ignition mode switch supply voltage circuit. The ground path for each LED is controlled by the BCM.

OBDII Code B0976 - Off Indicator Control Circuit - AutoCodes.com
B0976 Code - Off Indicator Control Circuit

Need More Information on the Code?

Need more information on how to fix the B0976 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the B0976 code diagnosed by a professional: Find a repair shop in your area

Code B0976 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0976 code? Have you replaced any parts?
Any information is appreciated. Thanks