AutoCodes - OBDII Code List - B00D5 FORD

B00D5 FORD - Restraint System Passenger Disable Indicator

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

B00D5 FORD Possible Causes

  • Faulty Restraint System Passenger Disable Indicator
  • Restraint System Passenger Disable Indicator harness is open or shorted
  • Restraint System Passenger Disable Indicator circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)

How do I fix code B00D5 FORD?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Tech Notes

B00D5:11 Restraint System Passenger Disable Indicator: Circuit Short to Ground
B00D5:12 Restraint System Passenger Disable Indicator: Circuit Short to Battery
B00D5:13 Restraint System Passenger Disable Indicator: Circuit Open

Cost of diagnosing the B00D5 FORD code

Labor: 1.0

The cost of diagnosing the B00D5 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B00D5 FORD Description

The Restraints Control Module (RCM) monitors all of Supplemental Restraint System (SRS) device connections. If the RCM detects a connection or device connected that is not stored in memory or is not configured for the component, the RCM will set a Diagnostic Trouble Code (DTC) and send a message to the Instrument Panel Cluster (IPC) to illuminate air bag warning indicator.
OBDII Code B00d5 Ford - Restraint System Passenger Disable Indicator - AutoCodes.com

More Information

Need more information on how to fix the B00D5 FORD code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B00d5 Ford code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B00d5 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧