AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jeep - P2119 Jeep

P2119 Jeep Code - Throttle Actuator Control Throttle Body Perfornance

- Code Popularity: 13,023 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2119 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Electronic Throttle Control (ETC) Motor
  • Electronic Throttle Control (ETC) Motor harness is open or shorted
  • Electronic Throttle Control (ETC) Motor circuit poor electrical connection
⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC P2119 Jeep?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2119 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2119 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The P2119 code is set when the Engine Control Module (ECM) detects an error during ETC relearn at key on.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No throttle pedal response

Code P2119 Jeep Description

The Engine Control Module (ECM) is the control center for the Throttle Actuator Control (TAC) system. The ECM determines the drivers intent and then calculates the appropriate throttle response. The ECM achieves throttle positioning by providing a pulse width modulated voltage to the TAC motor. The TAC system uses the following circuits for Motor control 1 and Motor control 2.
Two processors are also used to monitor the TAC system data. Both processors are located within the ECM. Both processors monitor each other's data to verify that the indicated throttle position is correct.

OBDII Code P2119 Jeep - Throttle Actuator Control Throttle Body Perfornance - AutoCodes.com
P2119 Jeep Code - Throttle Actuator Control Throttle Body Perfornance

Need More Information on the Code?

Need more information on how to fix the P2119 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2119 Jeep code diagnosed by a professional: Find a repair shop in your area

Code P2119 Jeep comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2119 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks