AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mitsubishi - P2096 Mitsubishi

P2096 Mitsubishi Code - Downstream Fuel Trim System 1 Lean

- Code Popularity: 16,221 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2096 Mitsubishi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low fuel pressure
  • Misfire condition
  • Large vacuum leak
  • Air leak near sensor
  • Plugged catalytic converter
  • Lean air/fuel ratio
  • Faulty front O2 sensor
⚠ Does your Mitsubishi have Safety Recalls? → Check here

How to Fix the DTC P2096 Mitsubishi?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2096 Mitsubishi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2096 Mitsubishi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2096 Mitsubishi Description

The catalyst's efficiency is demonstrated by its ability to oxidize CO and hydrocarbon emissions. The Powertrain Control Module (PCM) compares the output signals of the front and rear oxygen sensors to determine whether the output of the rear sensor is beginning to match the output of the front oxygen sensor. Air/fuel mixture compensation keeps the frequency of the front oxygen sensor high due to the changes from rich-to-lean combusition. The catalyst causes the rear oxygen sensor to have a lower frequency. As the catalyst wears, the rear oxygen sensor’s signal trace begins to match the front oxygen sensor’s signal trace. That is because the catalyst becomes saturated with oxygen and cannot use the oxygen to convert hydrocarbon and CO into H₂O and CO₂ with the same efficiency as when it was new. A completely worn catalyst shows a 100% match between the frequency of the front and rear sensors.

OBDII Code P2096 Mitsubishi - Downstream Fuel Trim System 1 Lean - AutoCodes.com
P2096 Mitsubishi Code - Downstream Fuel Trim System 1 Lean

Need More Information on the Code?

Need more information on how to fix the P2096 Mitsubishi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2096 Mitsubishi code diagnosed by a professional: Find a repair shop in your area

Code P2096 Mitsubishi comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2096 Mitsubishi code? Have you replaced any parts?
Any information is appreciated. Thanks