AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Dodge - P2092 Dodge

P2092 Dodge Code - 'A' Camshaft Position Actuator Control Circuit Low Bank 2

- Code Popularity: 3,149 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2092 Dodge?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Camshaft Position Actuator Solenoid Bank 2
  • Intake Camshaft Position Actuator Solenoid Bank 2 harness is open or shorted
  • Intake Camshaft Position Actuator Solenoid Bank 2 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Dodge have Safety Recalls? → Check here

How to Fix the DTC P2092 Dodge?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2092 Dodge Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2092 Dodge code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2092 Dodge Description

The Camshaft Position (CMP) Actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is operating. The CMP actuator solenoid signal from the ECM is Pulse Width Modulated (PWM). The ECM controls the CMP actuator solenoid duty cycle by controlling the amount of solenoid ON time. The CMP actuator solenoid controls the advance or the retard of each camshaft. The CMP actuator solenoid controls the oil flow that applies the pressure to advance or retard the camshafts.
Ignition voltage is supplied directly to the CMP actuator solenoid. The ECM controls the solenoid by grounding the control circuit with a solid-state device called a driver. The driver is equipped with a feedback circuit that is pulled-up to a voltage. The ECM can determine if the control circuit is open, shorted to ground, or shorted to a voltage by monitoring the feedback voltage.
The Diagnostic Trouble Code (DTC) will set if the ECM detects a short to ground in the CMP actuator solenoid circuits for more than 4 seconds or a cumulative of 50 seconds, when the solenoid is commanded OFF.
OBDII Code P2092 Dodge - 'A' Camshaft Position Actuator Control Circuit Low Bank 2 - AutoCodes.com
P2092 Dodge Code - 'A' Camshaft Position Actuator Control Circuit Low Bank 2

Need More Information on the Code?

Need more information on how to fix the P2092 Dodge code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2092 Dodge code diagnosed by a professional: Find a repair shop in your area

Code P2092 Dodge comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2092 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks