AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - P207E

P207E Code - Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2

- Code Popularity: 7,879 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P207E?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Manifold Tuning Valve Position Sensor/Switch
  • Intake Manifold Tuning Valve Position Sensor/Switch harness is open or shorted
  • Intake Manifold Tuning Valve Position Sensor/Switch circuit poor electrical connection
  • Faulty Intake Manifold Tuning Valve (IMTV)
  • Faulty Intake Manifold Runner Control (IMRC)
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC P207E?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P207E Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P207E code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P207E Description

The Intake Manifold Tuning Valve (IMTV) is a motorized actuated unit mounted directly to the intake manifold. The IMTV actuator controls a shutter device attached to the actuator shaft. There is no monitor input to the Powertrain Control Module (PCM) with this system to indicate shutter position.
The motorized IMTV unit will not be energized below approximately 2600 rpm or higher on some vehicles. The shutter will be in the closed position not allowing airflow blend to occur in the intake manifold. Above approximately 2600 rpm or higher, the motorized unit will be energized. The motorized unit will be commanded on by the PCM initially at a 100 percent duty cycle to move the shutter to the open position and then falling to approximately 50 percent to continue to hold the shutter open.
The Intake Manifold Tuning Valve (IMTV) system is monitored for failure during continuous, Key ON Engine OFF (KOEO), or Key ON Engine Running (KOER) self-tests. The test fails when the signal is more or less than an expected calibrated range.

OBDII Code P207E - Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2 - AutoCodes.com
P207E Code - Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2

Need More Information on the Code?

Need more information on how to fix the P207E code? Get Access to Factory Service Manuals

Information for Specific Makes

  • P207E Ford Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2
  • P207E Lincoln Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2
  • P207E Mercury Intake Manifold Tuning Valve Position Sensor/Switch Circuit Intermittent Bank 2

Need Help with the Code?

Get the P207E code diagnosed by a professional: Find a repair shop in your area

Code P207E comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P207E code? Have you replaced any parts?
Any information is appreciated. Thanks