AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Acura - P1362 Acura

P1362 Acura Code - Top Dead Center Sensor 1 No Signal

- Code Popularity: 15,734 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1362 Acura?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Top Dead Center Sensor 1
  • Top Dead Center Sensor 1 harness is open or shorted
  • Top Dead Center Sensor 1 circuit poor electrical connection
⚠ Does your Acura have Safety Recalls? → Check here

How to Fix the DTC P1362 Acura?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

2003 Acura TL Top Dead Center (TDC) sensor location:

Search for P1362 Acura Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1362 Acura code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Poor engine performance

Code P1362 Acura Description

The Crankshaft Position (CKP) Sensor determines the timing for fuel injection and ignition of each cylinder and also detects engine speed. The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when the crank angle is abnormal. The Cylinder Position (CYP) Sensor detects the position of the No. 1 cylinder for the sequential fuel injection to each cylinder. The CKP/TDC/CYP sensors are built into the distributor. If no Top Dead Center (TDC) sensor pulsing signals are detected, a malfunction is detected, and the P1382 Diagnostic Trouble Code (DTC) is stored.

OBDII Code P1362 Acura - Top Dead Center Sensor 1 No Signal - AutoCodes.com
P1362 Acura Code - Top Dead Center Sensor 1 No Signal

Need More Information on the Code?

Need more information on how to fix the P1362 Acura code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1362 Acura code diagnosed by a professional: Find a repair shop in your area

Code P1362 Acura comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1362 Acura code? Have you replaced any parts?
Any information is appreciated. Thanks