AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P1309 Ford

P1309 Ford Code - Misfire Detection Monitor Not enabled

- Code Popularity: 89,234 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1309 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Camshaft Position Sensor
  • Synchronize Assembly not properly installed.
  • Verify the cam sensor is synchronized
  • Faulty Powertrain Control Module (PCM)
  • Verify input sensor parameters are correct
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1309 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Replacing the Camshaft Position Sensor (CMP) usually takes care of the problem, but if the sensor is installed out of synchronization it will produce the P1309 code. If the CMP is installed properly, REPLACE Powertrain Control Module (PCM). RESTORE vehicle. RERUN Quick Test .

Search for P1309 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1309 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Powertrain Control Module (PCM) disabled the misfire monitor

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1309 Ford Description

Misfire Monitor Disabled When the misfire monitor is disabled, usually due to the input signal generated by the camshaft position (CMP) sensor, by sensing the passage of teeth from the CMP wheel.

OBDII Code P1309 Ford - Misfire Detection Monitor Not enabled - AutoCodes.com
P1309 Ford Code - Misfire Detection Monitor Not enabled

Need More Information on the Code?

Need more information on how to fix the P1309 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1309 Ford code diagnosed by a professional: Find a repair shop in your area

Code P1309 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1309 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks