AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P1130 Nissan

P1130 Nissan Code - Swirl Control Valve Control Solenoid Valve

- Code Popularity: 136,924 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1130 Nissan?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Swirl control valve control solenoid valve
  • Swirl control valve control solenoid valve circuit is open or shorted
  • Swirl control valve circuit is open or shorted
  • Faulty swirl control valve
  • Faulty Swirl control valve actuator
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P1130 Nissan?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1130 Nissan Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1130 Nissan code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The P1130 code is detected when an improper voltage signal is sent to Engine Control Module (ECM) through swirl control valve control solenoid valve.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1130 Nissan Description

This system has a swirl control valve in the intake passage of each cylinder.
While idling and during low engine speed operation, the swirl control valve closes. Thus the velocity of the air in the intake passage increases, promoting the vaporization of the fuel and producing a swirl in the combustion chamber.
Because of this operation, this system tends to increase the burning speed of the gas mixture, improve fuel consumption, and increase the stability in running conditions.
Also, except when idling and during low engine speed operation, this system opens the swirl control valve. In this condition, this system tends to increase power by improving intake efficiency via reduction of intake flow resistance, intake flow.
The solenoid valve controls swirl control valve’s shut/open condition. This solenoid valve is operated by the Engine Control Module (ECM).
The swirl control valve control solenoid valve responds to signals from the ECM. When the ECM sends an ON (ground) signal, the solenoid valve is bypassed to apply intake manifold vacuum to the swirl control valve actuator. This operation closes the swirl control valve. When the ECM sends an OFF signal, the vacuum signal is cut and the swirl control valve opens.

OBDII Code P1130 Nissan - Swirl Control Valve Control Solenoid Valve - AutoCodes.com
P1130 Nissan Code - Swirl Control Valve Control Solenoid Valve

Need More Information on the Code?

Need more information on how to fix the P1130 Nissan code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1130 Nissan code diagnosed by a professional: Find a repair shop in your area

Code P1130 Nissan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1130 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks